Hilti anchors, esr 305611/26/2022 Why do I need to clean the hole? Cleaning the hole prevents any dust that settles into the hole from potentially interfering with the Tapcon threads. What does ANSI stand for? The American National Standards Institute is a private, non-profit organization that oversees product standards, including masonry drill bits. This will ensure that any dust that settles in the hole will not interfere with the Tapcon threads. How deep do I drill the pilot hole? The drilled hole for a 3/16", 1/4" and 5/16" anchors requires a 1/4" deeper hole, and the 3/8" and 1/2" anchors require a 1/2" deeper hole. Are Genuine Blue Tapcon anchors building code-approved? Yes, Genuine Blue Tapcon anchors are building code-approved. What is Climaseal coating? It is a long-term corrosion resistant coating that covers the entire fastener surface. What diameters are available for Genuine Blue Tapcon? Original Genuine Tapcon comes in 3/16" and 1/4" diameters. What material is Genuine Blue Tapcon manufactured from? Genuine Blue Tapcon is manufactured from heat-treated carbon steel for increased hardness and ductility. What if I need to remove and/or move my application in the future? Tapcon anchors are reversible, allowing future removal of any application. Are inserts required for Tapcon anchors? No, while some masonry anchors use a lag shield, which are hammered into a hole, then threaded in, which can cause expansion pressure in the hole, Tapcon anchors cut threads into a hole, causing no expansion pressure in the hole. In addition, unlike expansion anchors, Tapcon anchors are removable allowing for greater flexibility on the job. This allows Tapcon anchors to be installed close to an edge and at reduced spacing. Tapcon anchors cut threads into the hole walls, eliminating pressure on the hole walls. How do Tapcon anchors differ from other types of concrete anchors? Expansion anchors, such as wedge and sleeve anchors provide holding power by expanding into the hole, which creates pressure on the hole walls. The low threads provide positive stability when the anchor is being driven. The high threads feature notched edges that easily and quickly cut into masonry materials. What is the Tapcon thread design? The patented Advanced Threadform Technology Hi-Lo twin-thread design literally taps threads into concrete, creating a mechanical linking that is reversible and removable. Can Tapcon anchors replace other types of anchors? Yes, Tapcon anchors can be used in place of traditional mechanical expansion anchors such as wedge anchors, sleeve anchors and plugs. Can Tapcon anchors be used in coastal and other highly corrosive environments? Yes, 410 Stainless Steel, White Ultrashield, coated Tapcons including Phillips, Hex, and Maxi-set headed anchors provide the highest degree of protection in highly corrosive environments. Click here for specific performance data. How much holding power does a Tapcon anchor provide? Tapcon anchor performance depends on the diameter of the screw, embedment depth and compressive strength of the concrete. Then drive the anchor into the pre-drilled hole until it is fully seated. Second, switch your drill out of hammer mode and position the Tapcon anchor into a nut driver or onto a Phillips bit. How do I install a Tapcon anchor? First, drill a hole using a hammer-drill or rotary hammer in the hammer mode. What are Tapcon screw anchors? Tapcon anchors are masonry screws designed with Advanced Threadform Technology ™, which cuts threads into all masonry materials including concrete, block and brick. What does "Tapcon" mean? The Tapcon name is derived from its ability to "tap" threads into "con"crete. Where are Tapcon anchors manufactured? All genuine Tapcon anchors are engineered and manufactured in the United States.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |